Sand Calculator
Sand for a sandbox, bedding under pavers or levelling, as cubic yards…
Sand for a sandbox, bedding under pavers or levelling, as cubic yards, tons and 50 lb bags.
More options0% extra · 2,740 lb/yd³ loose
Extra to allow
For spillage and uneven ground. A compacted layer’s own shrinkage is counted separately, from the loose and compacted weights.
MoDOT’s tables put loose sand at 2,630 to 2,960 lb/yd³. Your supplier’s figure is better: put it here.
TxDOT: tandem dump trucks usually carry 12 or 14 cubic yards; single-axle trucks about 6.
ExampleSand to order
1.83tons
1.34 cu yd loose.
Enter yours to see your result.
Bag size
- In bags
- 74 × 50 lb
- Area
- 36 sq ft
An estimate of materials to buy, not engineering or code advice. Check sizes with your supplier and local building department. Terms
My shopping list
Add each part of a job and print one list: a paver patio is base stone, bedding sand and the pavers; a fence is post holes. It stays on this device.
How this works: 11 sources,
How this works
Method
Sand is sold by the ton in bulk or in 50 lb bags. The calculator works out the volume from the area and depth, then the weight from a loose weight per cubic yard: MoDOT’s tables give 2,630 to 2,960 lb for loose sand and 2,830 to 3,180 compacted. Damp sand bulks up and weighs differently, so your supplier’s figure is better if you have it. Full method
Sources
- Highway Maintenance Tables and Conversion Factors: loose and compacted weights of materials (Missouri Department of Transportation, Engineering Policy Guide)
- QUIKRETE Mason Sand (No. 1961) data sheet (QUIKRETE, revised October 2023)
- Interlocking concrete pavement guide specification (PAV-TEC-009-13) (Interlocking Concrete Pavement Institute / CMHA, 2013)
- QUIKRETE Concrete Mix (No. 1101) data sheet (QUIKRETE, revised October 2022)
- Sakrete High Strength Concrete Mix data sheet (Sakrete (Oldcastle APG), REV 7-10)
- Sakrete Concrete Mix product data sheet (30 kg) (Sika Canada)
- CIP 31, Ordering Ready Mixed Concrete (National Ready Mixed Concrete Association, 2023)
- CIP 8, Discrepancies in Yield (National Ready Mixed Concrete Association)
- International Residential Code 2021: R311.3, R311.7.5, R403.1.1, R506.1 (International Code Council, 2021)
- Seal Coat and Surface Treatment Manual: haul trucks, size (Texas Department of Transportation)
- NIST Handbook 44 (2026), Appendix C: General tables of units of measurement (National Institute of Standards and Technology, 2026)
Limits
An estimate of materials to buy, not engineering or code advice. Check sizes with your supplier and local building department.
Privacy
On your device. Nothing you enter or open leaves this browser. About privacy labels
Changes
- First published: draw any area and see bags on a pallet, yards or trucks, with 14 job and material pages and a shopping list kept on your device.
How sand is worked out
Sand is sold by the ton in bulk or in 50 lb bags. The calculator works out the volume from the area and depth, then the weight from a loose weight per cubic yard: MoDOT’s tables give 2,630 to 2,960 lb for loose sand and 2,830 to 3,180 compacted. Damp sand bulks up and weighs differently, so your supplier’s figure is better if you have it.
For bedding sand under a 15 × 20 ft paver patio, at the 1 inch the paving guide specification gives: 300 sq ft × 1 ÷ 12 = 25 cubic feet, 0.93 cubic yards, about 1.27 tons or 51 bags of 50 lb.
A 50 lb bag holds about half a cubic foot: QUIKRETE’s data sheet gives 0.5 cu ft for its 50 lb Mason Sand. A sandbox 12 inches deep therefore takes two bags per square foot of floor, which is why a bulk load quickly becomes cheaper.
tons = area × depth ÷ 324 × weight per cubic yard ÷ 2,000
- Loose sand weighs 97 to 110 lb per cubic foot (2,630 to 2,960 lb a cubic yard). Source: Highway Maintenance Tables and Conversion Factors: loose and compacted weights of materials.
- A 50 lb bag of Mason Sand contains about 0.5 cubic feet. Source: QUIKRETE Mason Sand (No. 1961) data sheet.
- Bedding sand for interlocking pavers is screeded to a nominal 1 inch (25 mm). Source: Interlocking concrete pavement guide specification (PAV-TEC-009-13).
Sand for sandboxes, bedding and levelling
Loose, at 2,740 lb per cubic yard; 50 lb bags.
| Job | Depth | Cubic yards | Tons | 50 lb bags |
|---|---|---|---|---|
| Sandbox 4 × 4 ft | 12 in | 0.59 yd³ | 0.81 tons | 33 |
| Sandbox 6 × 6 ft | 12 in | 1.33 yd³ | 1.83 tons | 74 |
| Sandbox 8 × 8 ft | 12 in | 2.37 yd³ | 3.25 tons | 130 |
| Bedding under pavers, 100 sq ft | 1 in | 0.31 yd³ | 0.42 tons | 17 |
| Bedding under pavers, 300 sq ft | 1 in | 0.93 yd³ | 1.27 tons | 51 |
| Levelling a 10 × 10 ft area | 2 in | 0.62 yd³ | 0.85 tons | 34 |
Sources
- Missouri Department of Transportation, Engineering Policy Guide, Highway Maintenance Tables and Conversion Factors: loose and compacted weights of materials
- QUIKRETE, QUIKRETE Mason Sand (No. 1961) data sheet
- Interlocking Concrete Pavement Institute / CMHA, Interlocking concrete pavement guide specification (PAV-TEC-009-13)
QUIKRETE and Sakrete are trademarks of their owners; Binary Decimal is not affiliated with them. Their data sheets are cited for the yields printed on their bags.
Common questions
How much sand for a sandbox?
Length × width × depth. A 6 × 6 ft sandbox filled 12 inches deep holds 36 cubic feet, 1.33 cubic yards: about 1.8 tons, or 73 bags of 50 lb at MoDOT’s loose weight.
How much sand goes under pavers?
A 1 inch screeded bed, the nominal thickness in the interlocking pavement guide specification; Unilock says it should never be more than 1½ inches. That is 1 cubic foot for every 12 square feet of patio, plus joint sand later.
How many tons of sand in a yard?
About 1.3 to 1.5 tons loose, from MoDOT’s 2,630 to 2,960 lb per cubic yard. Wet sand can weigh more; very dry, fine sand less.