Battery Runtime Calculator
How long a battery runs your load, counting the inverter and the share you can use.
How long a battery will run your load, with the share you can use, the inverter’s losses and its idle draw, and Peukert’s law for lead-acid. For RVs, vans, boats, solar and backup power.
Battery type
The inverter’s efficiency and idle draw are under “Usable share, inverter and Peukert”.
Usable share, inverter and Peukert80% used, inverter 90%
Victron’s battery monitors default to using 50% of lead-acid and 80 to 90% of lithium. Your battery’s maker has the real figure.
Victron’s small inverters peak at 87 to 92%.
Its own use with no load: 4 to 12 W for those.
ExampleRuns for about
9 h 13 min
A 100 Ah 12.8 V lithium (LiFePO4) battery runs 100 W of AC through an inverter for about 9 h 13 min, using 80% of its 1.28 kWh.
Enter your own battery and load to see your runtime.
- Reaches the load: 921.6 Wh
- Inverter losses: 102.4 Wh
- Kept in reserve: 256 Wh
- Draw from the battery
- 111.1 W, 8.681 A
- Energy to the load
- 921.6 Wh
- At 80% you keep in reserve
- 256 Wh
Circuit physics for learning and planning, not wiring advice: installations must follow your local electrical code and a qualified electrician. Terms
How this works: 6 sources,
How this works
Method
Energy is capacity times voltage (Wh = Ah × V). Runtime is the energy you use (capacity × depth of discharge) divided by what the battery supplies: the load, divided by the inverter’s efficiency for AC, plus its idle draw. For lead-acid, Peukert’s law t = H × (C ÷ (I × H))^k scales the runtime for the discharge current against the capacity’s H-hour rating. A bank for days without charging is the daily energy × days ÷ (efficiency × depth of discharge).
Sources
- BMV-700 manual: discharge floor (50% lead-acid, 10 to 20% lithium) (Victron Energy)
- BMV-700 manual: battery capacity and Peukert exponent (1.25 default) (Victron Energy)
- Peukert’s law (Wikipedia)
- Phoenix Inverter VE.Direct 250 to 1200 VA datasheet (max. efficiency 87 to 92%, zero-load power 4.2 to 12 W) (Victron Energy)
- 12.8 V and 25.6 V Lithium SuperPack datasheet (2,500 cycles at 80% DoD) (Victron Energy)
- PackSafe: lithium batteries (100 Wh and 160 Wh limits) (US Federal Aviation Administration)
How it’s tested
13 worked examples for this page are checked by automated tests before every release: given the inputs, the tool must show the expected answer.
Limits
Circuit physics for learning and planning, not wiring advice: installations must follow your local electrical code and a qualified electrician.
Privacy
On your device. Nothing you enter or open leaves this browser. About privacy labels
Changes
- First published: battery runtime with depth of discharge, inverter losses and idle draw, and Peukert’s law, plus Ah to Wh, mAh to Wh with flight limits, and battery bank size pages.
Key facts
- Battery energy in watt hours is amp hours times volts: 100 Ah at 12.8 V is 1,280 Wh.
- Victron’s battery monitors use 50% of a lead-acid battery by default and suggest 80 to 90% for lithium.
- Victron’s small Phoenix inverters peak at 87 to 92% efficiency and draw 4 to 12 W with no load.
Sources: Victron Energy BMV-700 manual and Phoenix inverter datasheet
All 3 calculators
Capacity · Planning
Where a battery’s energy goes
The picture on the card is the battery’s energy as a budget. Some stays in reserve, because using all of it shortens the battery’s life. Of the rest, an inverter turns part into heat while making AC, and its own idle draw takes a little more. A lead-acid battery delivers less again when drained quickly. What’s left reaches the load, and that sets the runtime.
The result is an estimate for a steady load at room temperature. Real loads cycle (a fridge’s compressor runs part of the time, so use its average power), cold weather cuts a battery’s capacity, and batteries lose capacity as they age. Leave a margin.
Sources
- Victron Energy, BMV-700 manual: discharge floor (50% lead-acid, 10 to 20% lithium)
- Victron Energy, BMV-700 manual: battery capacity and Peukert exponent (1.25 default)
- Wikipedia, Peukert’s law
- Victron Energy, Phoenix Inverter VE.Direct 250 to 1200 VA datasheet (max. efficiency 87 to 92%, zero-load power 4.2 to 12 W)
- Victron Energy, 12.8 V and 25.6 V Lithium SuperPack datasheet (2,500 cycles at 80% DoD)
- US Federal Aviation Administration, PackSafe: lithium batteries (100 Wh and 160 Wh limits)
Common questions
How long will a 100 Ah battery last?
It depends on the voltage, the load and how much of it you use. A 12.8 V 100 Ah lithium battery holds 1,280 Wh; using 80% of it through a 90% inverter runs a 100 W load for about 9 hours, a 500 W load for under 2. A 12 V 100 Ah lead-acid battery used to 50% gives about half that at 100 W and about a third at 500 W, since it also delivers less at high currents.
How do I work out battery runtime?
Multiply the capacity in Ah by the voltage to get Wh, take the share you will use, and divide by what the battery supplies: the load in watts, divided by the inverter’s efficiency for AC loads, plus the inverter’s own idle draw. The answer is in hours.
What is depth of discharge?
The share of the battery’s capacity you take out before recharging. Running a lead-acid battery flat shortens its life sharply, so a common setting is 50%; Victron’s monitors default to that. Lithium iron phosphate is usually used to 80 or 90%. Your battery’s maker gives the figure for the cycle life you want.
Why does my lead-acid battery run out sooner at high loads?
A lead-acid battery’s capacity is rated at a slow discharge, often over 20 hours, and it delivers less when drained faster. Peukert’s law models that with an exponent; the calculator applies it for lead-acid, starting at 1.25, the default in Victron’s battery monitors (1.05 for lithium).
Does the inverter matter if the load is small?
Yes. An inverter draws power just being on, often several watts, which is a large share of a small load: an 8 W idle draw shortens a 100 W runtime by about 7%, and a 20 W one by much more. Run small DC loads directly from the battery where you can.