Crushed Stone Calculator
Tons of crushed stone for a shed base, a drainage trench or a sub-base…
Tons of crushed stone for a shed base, a drainage trench or a sub-base, with the extra a compacted layer needs.
More options0% extra · 2,500 lb/yd³ loose · compacted +27%
Extra to allow
For spillage and uneven ground. A compacted layer’s own shrinkage is counted separately, from the loose and compacted weights.
MoDOT’s tables put loose crushed stone at 2,410 to 2,590 lb/yd³. Your supplier’s figure is better: put it here.
TxDOT: tandem dump trucks usually carry 12 or 14 cubic yards; single-axle trucks about 6.
ExampleCrushed stone to order
3.54tons
2.83 cu yd loose, to compact to 2.23 cu yd.
Enter yours to see your result.
Bag size
- In bags
- 142 × 50 lb
- Extra for compaction
- 27%
- Area
- 120 sq ft
An estimate of materials to buy, not engineering or code advice. Check sizes with your supplier and local building department. Terms
My shopping list
Add each part of a job and print one list: a paver patio is base stone, bedding sand and the pavers; a fence is post holes. It stays on this device.
How this works: 9 sources,
How this works
Method
Crushed stone is quarried rock broken to size: #57 stone (graded from 1 inch down) for drainage, finer screenings for packing, and crusher run, a mix of sizes down to dust that compacts hard. It is usually sold by the ton, so the calculator turns the volume into weight, using MoDOT’s loose and compacted weights for crushed limestone and granite. Full method
Sources
- Highway Maintenance Tables and Conversion Factors: loose and compacted weights of materials (Missouri Department of Transportation, Engineering Policy Guide)
- Seal Coat and Surface Treatment Manual: haul trucks, size (Texas Department of Transportation)
- QUIKRETE Concrete Mix (No. 1101) data sheet (QUIKRETE, revised October 2022)
- Sakrete High Strength Concrete Mix data sheet (Sakrete (Oldcastle APG), REV 7-10)
- Sakrete Concrete Mix product data sheet (30 kg) (Sika Canada)
- CIP 31, Ordering Ready Mixed Concrete (National Ready Mixed Concrete Association, 2023)
- CIP 8, Discrepancies in Yield (National Ready Mixed Concrete Association)
- International Residential Code 2021: R311.3, R311.7.5, R403.1.1, R506.1 (International Code Council, 2021)
- NIST Handbook 44 (2026), Appendix C: General tables of units of measurement (National Institute of Standards and Technology, 2026)
Limits
An estimate of materials to buy, not engineering or code advice. Check sizes with your supplier and local building department.
Privacy
On your device. Nothing you enter or open leaves this browser. About privacy labels
Changes
- First published: draw any area and see bags on a pallet, yards or trucks, with 14 job and material pages and a shopping list kept on your device.
How crushed stone is worked out
Crushed stone is quarried rock broken to size: #57 stone (graded from 1 inch down) for drainage, finer screenings for packing, and crusher run, a mix of sizes down to dust that compacts hard. It is usually sold by the ton, so the calculator turns the volume into weight, using MoDOT’s loose and compacted weights for crushed limestone and granite.
For a French drain 1.5 ft wide, 60 ft long and 12 inches deep of loose stone: 90 sq ft × 1 ft = 90 cubic feet, 3.34 cubic yards, about 4.2 tons at 2,500 lb a yard. Drain stone is not compacted, so pick Loose; a base under a shed or patio is compacted in layers, so pick Compacted.
Washed clean stone such as #57 has more air between the pieces than crusher run, so it weighs less per yard and hardly compacts. If your supplier quotes a weight per yard or a tons-per-yard figure for their product, put it in and the tons follow it.
tons = cubic yards × weight per cubic yard ÷ 2,000
- Loose granite or limestone: 89 to 96 lb per cubic foot (2,410 to 2,590 lb a cubic yard); compacted 113 to 122 lb per cubic foot. Source: Highway Maintenance Tables and Conversion Factors: loose and compacted weights of materials.
- Single-axle trucks normally carry 6 cubic yards of aggregate. Source: Seal Coat and Surface Treatment Manual: haul trucks, size.
Crushed stone for common jobs
Bases compacted (the yards are loose stone to order); the drain trench loose. MoDOT weights.
| Job | Depth | Yards to order | Tons |
|---|---|---|---|
| Shed base 8 × 10 ft | 4 in | 1.26 yd³ | 1.57 tons |
| Shed base 10 × 12 ft | 6 in | 2.83 yd³ | 3.53 tons |
| Shed base 12 × 16 ft | 6 in | 4.52 yd³ | 5.65 tons |
| Driveway 10 × 40 ft | 6 in | 9.42 yd³ | 11.78 tons |
| Driveway 12 × 50 ft | 8 in | 18.84 yd³ | 23.56 tons |
| Drain trench 1 × 50 ft | 18 in | 2.78 yd³ | 3.47 tons |
Common questions
How much does a yard of crushed stone weigh?
MoDOT’s tables give 2,410 to 2,590 lb (1.2 to 1.3 tons) for a loose cubic yard of crushed granite or limestone, and 3,060 to 3,300 lb once compacted. Other rock, such as trap rock, is heavier.
How deep should crushed stone be under a shed?
A compacted base of 4 to 6 inches is common for a shed on a gravel pad, set by the shed maker’s instructions and your ground. Put the depth you want once compacted; the calculator orders the loose stone to make it.
What is the difference between #57 stone and crusher run?
Number 57 is washed stone graded from about 1 inch down to ³⁄₁₆ inch (ASTM C33 size 57), with gaps that let water through: good for drains. Crusher run keeps the fines, so it packs into a hard surface: good for driveways and bases. Both are crushed stone; their weights per yard differ a little.